Power connector cable
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
●
Service cover (see
●
Keyboard (see
●
Top cover (see
To remove the power connector cable:
1.
Position the computer upright.
2.
Disconnect the power connector cable (1) from the system board.
3.
Remove the power connector cable (2).
Reverse this procedure to install the power connector cable.
Battery on page
49), and then remove the following components:
Service cover on page
Keyboard on page
57)
Top cover on page
60)
55)
Component replacement procedures
Spare part number
760104-001
73