USB board
Description
USB board (includes cable)
Before removing the USB board, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4.
Remove the battery (see
●
Service cover (see
●
Keyboard (see
●
Top cover (see
To remove the USB board:
1.
Position the computer upright.
2.
Lift the ZIF connector (1), and then disconnect the USB board cable from the system board (2).
3.
Remove the Phillips PM2.5×3.0 screw (3) that secures the USB board to the base enclosure.
4.
Remove the USB board (4).
Reverse this procedure to install the USB board.
Battery on page
49), and then remove the following components:
Service cover on page
Keyboard on page
57)
Top cover on page
60)
55)
Component replacement procedures
Spare part number
757608-001
67