Cisco ASR 5000 Series Installation And Administration Manual page 60

▀ Installing L-ESS Application in Cluster Mode
Parameter Description
Transient file prefix Type the transient file prefix for source files. This is a customer specific unique text prefix to
for source distinguish the incomplete files from final files.
Transfer file prefix Type the transfer file prefix for destination files. This is a customer specific unique text
for destination prefix to distinguish the incomplete files from final files.
Pending file If number of total files to be fetched from source directory is larger than this threshold
threshold number then alarm "starLESSThreshPendingFiles" will be raised if SNMP feature is enabled.
Alarms will be raised even if the files to be pushed to destination directory is exceeding the
configured limit.
Clear alarm "starLESSThreshClearPendingFiles" will be raised when number of total files to
be fetched falls below this threshold. The threshold value, 0 indicates do not enable this
threshold. Maximum value for this threshold is 1000 files.
Half cooked file Type the threshold value, in hours, to avoid the unnecessary half cooked files being stored
detection threshold under chassis‟ base directory. If incomplete file older than this threshold is found, then L-
ESS removes the file. The value must be an integer from 1 through 24.
Port Type the port number used to create SFTP connection to remote host.
Connection retry This value is used to decide number of times L-ESS can try to set up connection to remote
count host in case of connection failure.
Connection Retry This is the time interval after which L-ESS should reconsider connecting to remote host in
Frequency case connection creation has failed earlier even after retrying configured number of times.
Socket timeout Use this parameter to set the socket timeout value. This socket timeout is set for a socket
value connection that is opened for SFTP between L-ESS and configured host or remote
destination. This is like a normal socket timeout which means maximum time for which
socket can remain idle. The default value is 10 seconds.
Compressed/Decom This value indicates if compression or decompression is required at the destination end while
pressed required sending the files. Possible values are c and d.
If it is c, it means that every file received will be compressed before sending to destination,
unless it is already compressed. If the value is d, it means that every file received will be
decompressed before sending to destination unless it is already decompressed.
Process count Specify the number of processes to be spawned for each source/destination.
Create hostname
Type (y)es to create a directory with hostname while pushing the files to destination. To have
directory this feature enabled it is necessary that HostName parameter has some value for given source.
Source Configuration
Source Location Select (L)ocal or (R)emote depending on the location of source.
Source directory Type the path for xDR base directory on chassis or on local source. This is the base directory
on chassis from which L-ESS will pull xDR files.
Hostname for Type the host name of subdirectory created at source side. This configuration is applicable
subdirectory only for local source. In case of remote source, remote host name is used to create directory.
Filter Type the unique string that is used to identify the xDR files to be included or excluded based
on filter list. If the filter string is provided, L-ESS will pull/push files only with matching
filter string.
For example, the include filter list can be [MIP,OCS] and the exclude filter list can be
![ACR,NBR].
▄ Cisco ASR 5000 Series External Storage Server Installation and Administration Guide
60
L-ESS Installation and Configuration
Default
Value
curr_
curr_
0
1
22
3
60
10
c
1
y
Local
Null
Null
Null
OL-22979-03