Cisco ASR 5000 Series Installation And Administration Manual page 52

▀ Installing L-ESS Application in Stand-alone Mode
Parameter Description
Transient file Type the transient file prefix for source files. This is a customer specific unique
prefix for source text prefix to distinguish the incomplete files from final files.
Transfer file Type the transfer file prefix for destination files. This is a customer specific
prefix for unique text prefix to distinguish the incomplete files from final files.
destination
Pending file If SNMP feature is enabled and the number of total files to be fetched from
threshold source directory is larger than this threshold number then alarm
"starLESSThreshPendingFiles" will be raised.
Alarms will be raised even if the files to be pushed to destination directory is
exceeding the configured limit.
Clear alarm "starLESSThreshClearPendingFiles" will be raised when number of
total files to be fetched falls below this threshold. The threshold value, 0
indicates do not enable this threshold. Maximum value for this threshold is 1000
files.
Half cooked file Type the threshold value, in hours, to avoid the unnecessary half cooked files
detection being stored under chassis‟ base directory. If incomplete file older than this
threshold threshold is found, then L-ESS removes the file.The value must be an integer
from 1 through 24.
Port Type the port number used to create SFTP connection to remote host.
Connection retry This value is used to decide number of times L-ESS can try to set up connection
count to remote host in case of connection failure.
Connection This is the time interval after which L-ESS should reconsider connecting to
Retry Frequency remote host in case connection creation has failed earlier even after retrying
configured number of times.
Socket timeout Use this parameter to set the socket timeout value. This socket timeout is set for a
value socket connection that is opened for SFTP between L-ESS and configured host
or remote destination. This is like a normal socket timeout which means
maximum time for which socket can remain idle. The default value is 10
seconds.
Compressed/Dec This value indicates if compression or decompression is required at the
ompressed destination end while sending the files. Possible values are c and d.
required If it is c, it means that every file received will be compressed before sending to
destination, unless it is already compressed. If the value is d, it means that every
file received will be decompressed before sending to destination unless it is
already decompressed.
Process count Specify the number of processes to be spawned for each source/destination.
Create hostname Type (y)es to create a directory with hostname while pushing the files to
directory destination. To have this feature enabled it is necessary that HostName parameter
has some value for given source.
Source Configuration
Source Location Select (L)ocal or (R)emote depending on the location of source.
Source directory Type the path for xDR base directory on chassis or on local source. This is the
base directory on chassis from which L-ESS will pull xDR files.
▄ Cisco ASR 5000 Series External Storage Server Installation and Administration Guide
52
L-ESS Installation and Configuration
Default Value
curr_
Null
0
1
22
3
60
10
c
1
y
Local
Null
OL-22979-03