Cisco ASR 5000 Series Installation And Administration Manual page 58

▀ Installing L-ESS Application in Cluster Mode
Parameter Description
Local file deletion Type the value, in hours, at which the L-ESS cleanup script should start deleting the older
time files. This can be adjusted so that cleanup script does not cause slowing down of L-ESS. The
value must be an integer from 0 through 23.
The above mentioned parameters are stored in a configuration file, generic_ess_config, located at <less_install_dir>ess/template
directory. The ess process when started by PSMON will take the configuration from this file. If you would like to change any of
the existing configuration, or set additional parameters, see the L-ESS Server Configuration section in this guide.
L-ESS Installation Confirmation
Modify
Type (Y)es if you want to make any modifications to the existing configuration.
configuration
Proceed with Type (Y)esto proceed with L-ESS installation.
installation
The following prompt appears when you proceed with the L-ESS installation:
[1] Modify Common Configurations For Source/Destination
[2] Add Source
[3] Modify Source
[4] Remove Source
[5] Enable Source
[6] Disable Source
[7] Add Destination
[8] Modify Destination
[9] Remove Destination
[10] Enable Destination
[11] Disable Destination
[12] Miscelleneous Configurations
[13] Show All Config
[e] Exit
Enter your choice according to the configurations needed.
Common Config Parameters for Source/Destination
▄ Cisco ASR 5000 Series External Storage Server Installation and Administration Guide
58
Important:
This parameter can be configured only when the File expiry
duration parameter is set to a non-zero value.
L-ESS Installation and Configuration
Default
Value
0
No
Yes
OL-22979-03