Dhcp Server Configuration(For The N8900); Storage Management; Disks Information - Thecus N3200XXX Series User Manual

NOTE
NOTE

DHCP Server Configuration(For the N8900)

A DHCP server can be configured to assign IP addresses to devices connected to the
LAN3 port. To configure these ports, choose Additional LAN3 Configuration from
the System Network menu.
DHCP Configuration
Item
DHCP Server
Lowest IP in Range
Highest IP in Range
DNS Server
NOTE
WARNING

Storage Management

The Storage menu displays the status of storage devices installed in the Thecus IP
storage, and includes storage configuration options such as RAID and disk settings,
folder configuration, space allocation and ISO Mount.

Disks Information

From the Storage menu, choose the Disks item and the Disks Information
screen appears. From here, you can see various items about installed SATA hard
disks. Blank lines indicate that a SATA hard disk is not currently installed in that
particular disk slot.
NOTE
Before enabling Jumbo Frame Support, please make sure your network equipment
supports Jumbo Frame. If your equipment is incompatible, you might not be able to
connect to your Thecus IP storage.
If the IP sharing mode setting is set to "Enable" under WAN/LAN1 port, then this 2
gateway cannot be configured.
Description
Enable or disable the DHCP server to automatically assign IP
address to PCs connected to the LAN3 interface.
Specifies the starting IP address of the DHCP range.
Specifies the ending IP address of the DHCP range.
Displayed the DNS server IP address.
The IP Segment of WAN/LAN1, LAN2 and LAN3 should not overlap.
The IP address of the LAN3 interface should not be in the range of the
Start IP address and End IP address.
• The screen shot below just example from Thecus IP Storage. The disk
slots can from 4 to 8 depend on the model of Thecus IP storage.
75
nd