Display Mode - Thecus N3200XXX Series User Manual

Display Mode

During normal operation, the LCD will be in Display Mode.
Display Mode
Item
Host Name
WAN/LAN1
LAN2
Link Aggregation
System Fan1
System Fan2
CPU Fan
2009/05/22 12:00
Disk Info
RAID
The Thecus IP storage will rotate these messages every one-two seconds on the
LCD display.
USB Copy
The USB Copy function enables you to copy files stored on USB devices such as USB
disks and digital cameras to the Thecus IP storage by press button. To use USB copy,
follow the steps below:
1. Plug your USB device into an available USB port on the Front end.
2. In Display Mode, press the Down Button (▼).
3. The LCD will display "USB Copy?"
4. Press Enter (
connected to the front USB port.
5. All of data will be copied into system folder named "USB copy".
Management Mode
During setup and configuration, the LCD will be in Management Mode.
To enter into Management Mode, press Enter (
will show on the LCD.
At this time, the administrator has to enter the correct LCD password. System will
check whether the correct LCD password has been entered. The default LCD
password is " 0000 ". If correct password is entered, you will enter into the
Management Mode menu.
Management Mode
Item
WAN/LAN1 Setting
LAN2 Setting
Link Agg. Setting
Change Admin Passwd
Reset to Default
Exit
Description
Current host name of the system.
Current WAN/LAN1 IP setting.
Current LAN2 IP setting.
Current Link Aggregation status
Current system fan1 status.
Current system fan2 status.
Current CPU fan status
Current system time.
Current status of disk slot has been installed
Current RAID status.

) and the Thecus IP storage will start copying USB disks
Description
IP address and netmask of your WAN/LAN1 ports.
IP address and netmask of your LAN2 ports.
Select Load Balance, 802.3ad or Failover.
Change administrator's password for LCD operation.
Reset system to factory defaults.
Exit Management Mode and return to Display Mode.
)
and an "Enter Password" prompt
48