Thecus N3200XXX Series User Manual page 72

WAN/LAN1 Configuration
Item
Host name
Domain name
WINS Server
MAC Address
Jumbo Frame Support
IP Sharing Mode
Link Aggregation
Set IP Address by:
Static / Dynamic
IP
Netmask
Gateway
DNS Server
NOTE
Description
Host name that identifies the Thecus IP storage on the network.
Specifies the domain name of Thecus IP storage.
To set a server name for NetBIOS computer.
MAC address of the network interface.
Enable or disable Jumbo Frame Support of the WAN/LAN1 interface on your
Thecus IP storage.
When enabled, PCs connected to the LAN2 port will be able to access the
WAN/LAN1.
Specifies whether WAN/LAN1 and LAN2 ports will be aggregated and act as
one port. There are 6 modes can be choose from:
Load Balance/Fail-over/Balance-XOR/802.3ad/Balance-TLB/Balance-ALB
You can choose a static IP or Dynamic IP, and input your network
configuration
IP address of the WAN/LAN1 interface.
Network mask, which is generally: 255.255.255.0
Default Gateway IP address.
Domain Name Service (DNS) server IP address.
• Only use Jumbo Frame settings when operating in a Gigabit environment
where all other clients have Jumbo Frame Setting enabled.
• Enabling DHCP automatically turns on UPnP— see the Service Support Screen.
• If you are only using the WAN/LAN1 port, we suggest that you disable IP
Sharing Mode. This will result in higher throughput.
• A correct DNS setting is vital to networks services, such as SMTP and NTP.
• To use the Link Aggregation with "802.3ad selected" feature, please make sure
the networking equipment on the other end of Ethernet cable also supports
802.3ad protocol.
72