Dhcp Server Configuration; Lan3(For The N8900) - Thecus N3200XXX Series User Manual

DHCP Server Configuration

A DHCP server can be configured to assign IP addresses to devices connected to the
LAN2 port. To configure these ports, choose LAN2 from the System Network
menu.
DHCP Configuration
Item
DHCP Server
Start IP
End IP
DNS Server
NOTE
WARNING

LAN3(For the N8900)

LAN3 Configuration
The N8900 supports three Gigabit Ethernet ports for higher service availability. To
configure these ports, choose Additional LAN 3 from the System Network menu,
and the Additional LAN3 Configuration screen appears. Press Apply to save
your changes.
Additional LAN3 Configuration
Item
MAC Address
Jumbo Frame Support
IP
Netmask
Gateway
Link Detected
Lick Speed
Description
Enable or disable the DHCP server to automatically assign IP
address to PCs connected to the LAN2 interface.
Specifies the starting IP address of the DHCP range.
Specifies the ending IP address of the DHCP range.
Displayed the DNS server IP address.
The IP Segment of WAN/LAN1 and LAN2 should not overlap.
The IP address of the LAN2 interface should not be in the range of the
Start IP address and End IP address.
Description
Displays the MAC address of the LAN3 interface.
Enable or disable Jumbo Frame Support on the LAN3 interface.
Specifies the IP address of the LAN3 interface.
Specifies the Network Mask of the LAN3 interface.
When Thecus NAS as a DHCP server from LAN3, it can have
another route to balance traffic bandwidth for its DHCP
clients
Specifies the LAN3 port link status
Specifies the LAN3 port link speed
74