Lan2 - Thecus N3200XXX Series User Manual

WARNING

LAN2

LAN2 Configuration
The Thecus IP storage supports two Gigabit Ethernet ports for higher service
availability. To configure these ports, choose LAN2 from the System Network
menu, and the LAN2 Configuration screen appears. Press Apply to save your
changes.
LAN2 Configuration
Item
MAC Address
Jumbo Frame Support
IP
Netmask
Gateway
Link Detected
Lick Speed
NOTE
NOTE
Most Fast Ethernet (10/100) Switches/Routers do not support Jumbo Frame and you will not
be able to connect to your Thecus IP Storage after Jumbo Frame is turned on. If this
happens, turn off the Thecus IP Storage. Then, insert USB disk with factory reset utility
included and power on the Thecus IP Storage. Till the system power on complete then it will
bring your system settings back to factory default.
Description
Displays the MAC address of the LAN2 interface.
Enable or disable Jumbo Frame Support on the LAN2 interface.
Specifies the IP address of the LAN2 interface.
Specifies the Network Mask of the LAN2 interface.
When Thecus NAS as a DHCP server from LAN2, it can have
another route to balance traffic bandwidth for its DHCP
clients
Specifies the LAN2 port link status
Specifies the LAN2 port link speed
Before enabling Jumbo Frame Support, please make sure your network equipment
supports Jumbo Frame. If your equipment is incompatible, you might not be able to
connect to your Thecus IP storage.
If the IP sharing mode setting is set to "Enable" under WAN/LAN1 port, then this 2
gateway cannot be configured.
73
nd