HCD-FL5D
3-16. TRAY (SUB)
1 Rotating the pulley (LD), shift the slider (selection) in the arrow A direction.
2 Rotating the pulley (mode) in the arrow direction, adjust the tray (sub) to be removed.
3 Rotating the pulley (LD), shift the slider (selection) in the arrow B direction.
4 Rotating the pulley (mode) in the arrow direction, remove the tray (sub) to be removed.
3-17. CHASSIS (MOLD B) SECTION, STOCKER SECTION, SLIDER (SELECTION)
5 two step
screws
18
pully (LD)
stocker section
tray (sub)
6 stocker
section
Pully (LD)
4 two step screws
A
7 two screws
(PTPWH M2.6)
8 slider (selection)
9 washer
0 compression
spring
3 gear (eject)
slider (selection)
B
pully (mode)
1 three screws
(BVTP M2.6)
2 chassis (mold B) section
Note: Rotating the pully (LD),
shift the slider (selection)
to the left.