Completion - RS Feva Owner's Manual

sheet through the
11) Take the other end of the
into the block on the other side. Tie the two ends of the
Picture 3.29 Tying the Gennaker Sheets
12) Pull the gennaker
anything is twisted.
13) Finally, pull the
Now you are almost ready to go Feva sailing. All that is left to do is:
• Fit the rudder
• Tidy the halyards
• Check that all knots and
1) To fit the rudder, simply line up the pins with the fitting on the back of the
boat and push down until the
may be difficult to get on at first – all it will need is a simple wiggle from side
to side whilst pushing down.
2) To remove the rudder, simply push the
3) Coil the main
picture 3.16).
block by the port-side
gennaker
from one side to the other, as if you were gybing, to see if
gennaker down into the

3.11 Completion

to the back of the boat
away
shackles
retaining clip
and jib halyards neatly and stow them in the
TIME TO GO SAILING!
shroud adjuster plate
sheet, pass it around the front of the jib, and
Picture 3.30 The Gennaker Sheet Block
gennaker chute.
are tied securely
'clicks' into place. The
retaining clip
(see picture 3.30).
gennaker sheet together.
rudder
in and pull the stock
halyard bag
up.
(see