Completion - RS Quba Rigging Manual

Now you are almost ready to go Q
• Fit the rudder
• Check that all the knots and
• Check that the
1. To fit the rudder, simply line up the pins on the
the back of the boat and push down until the retaining clip 'clicks' into place.
The rudder
from side to side whilst pushing down.
2. To remove the rudder, simply push the retaining clip in and pull the
stock up.
After launching, the
cleating it. The daggerboard
water is deep enough, make sure the retaining elastic is clipped to the mast! It is
normally best to leave the
appropriate once you are sailing.
Make sure that you un-cleat the rudder and raise the daggerboard before

3.10 Completion

UBA
to the back of the boat
shackles
bung is securely in the back of the boat.
may be difficult to get on at first – all it will need is a simple wiggle
TIME TO GO SAILING!
rudder is lowered by pulling the
can be inserted in the
kicking strap
coming ashore.
sailing. All that is left to do is:
are tied securely.
rudder stock
daggerboard case
loose while launching, pulling it on as
TOP TIP
with the fitting on
rudder downhaul line
when the
rudder
and