Initial Start Up - AEG CompuMaster 300 Operating Manual

4.4 Initial start-up
Marking of the mains switch (item 3 of pict. on page 46):
,,I" for ,ON" and ,,O" for ,,OFF"
1) Make sure, that the mains switch of UPS is in the
OFF-position (item 3 of picture on page 46)
2) Connect the input of UPS (item 12 of pict. on page 46)
with the connection cable (female contact) enclosed
and plug the connector to a suitable wall plug with
earthing contact.
3) Connect the output of the UPS (item 11 of picture on
page 46) to the load. Please use the enclosed second
connection cable only. The load (e.g. PC) should still
be switched off.
4) Set the mains switch of UPS to the ON-position.
5) The UPS will start with a self test changing automati-
cally to normal operation afterwards. In the case that
the UPS will be remaining in testing mode, please fol-
low the instructions in chapter 4.6 ,,Danger signals"
If you can' t find any solution concerning the problem
contact your dealer.
6) When the UPS is running in normal operation, please
switch on your load (e.g. PC).
Afterwards the UPS should remain in the ON-position for
battery charging for two days. Thus the battery capacity
will be increased to a normal state.