Introduction - Baxi Barcelona Installation And Servicing Instructions

1.0 Introduction – page 4
Fig.1
Fig. 2
"Benchmark" Log Book
As part of the industry-wide "Benchmark" initiative all Baxi
boilers now include an Installation, Commissioning and
Service Record Log Book. Please read the Log Book
carefully and complete all sections relevant to the
appliance and installation. These include sections on the
type of controls employed, flushing the system, burner
operating pressure etc. The details of the Log Book will be
required in the event of any warranty work. Also, there is a
section to be completed at each subsequent regular
service visit.
Baxi Limited declare that no substances harmful to health
are contained in the appliance or used during appliance
manufacture.
NOTE: This appliance must be installed in accordance with
the manufacturer's instructions and the regulations in force,
and only used in a suitably ventilated location.
All systems must be thoroughly flushed and treated
with inhibitor (see Section 6.2).
Read the instructions fully before installing or using the
appliance
1.1 Description
1. The Baxi Barcelona is a gas fired room sealed fan
assisted condensing central heating boiler.
2. The maximum output of the boiler is preset at 80,000
Btu/hr. The boiler will automatically adjust down to
30,000 Btu/hr according to the system load. If required,
the output can be set to 100,000 Btu/hr. Please refer to
section 8.8.
3. It is designed for use on Natural Gas (G20).
4. The boiler is suitable for fully pumped open vented
central heating and domestic hot water systems and
sealed systems.
5. A label giving details of the model, serial number and
Gas Council number is situated on the rear of the lower
door panel (Fig. 1).
6. The boiler data badge is positioned on the air box door
(Fig. 2).
7. The boiler is intended to be installed in residential /
commercial / light industrial E.M.C. environments on a
governed meter supply only.
8. The boiler must be installed with one of the purpose
designed flues such as the standard horizontal flue kit,
part nº 236921.
1.2 Important Information
This product contains Refractory Ceramic Fibres (R.C.F.)
which are man-made vitreous silicate fibres. Excessive
exposure to these materials may cause temporary irritation
to eyes, skin and respiratory tract. Care must be taken when
handling these articles to ensure the release of dust or fibres
is kept to a minimum.
To ensure that the release of fibres from these articles is
kept to a minimum, during installation and servicing it is
recommended that a HEPA. filtered vacuum is used to
remove any dust, soot or other debris accumulated in and
around the appliance. This should be performed before and
after working on the installation.
It is recommended that any replaced item(s) are not broken
up but sealed within heavy duty polythene bags and clearly
labelled "R.C.F. waste". This is not classified as "hazardous
waste" and may be disposed of at a tipping site licensed for
the disposal of industrial waste.
Protective clothing is not required when handling these
articles but it is recommended that gloves are worn and the
normal hygiene rules of not smoking, eating or drinking in
the work area are followed and always wash hands before
eating or drinking.