Aux - HIKVISION DS-2DF5284-A User Manual

5 Inch Network High-definition Speed Dome User Manual
WINDOW NUMBER
WINDOW ENABLE
<WINDOW SETTINGS>
<CLEAR WINDOW>

WINDOW SETTINGS
To set a window blanking area:
1. Use the joystick or direction buttons to position the cursor beside WINDOW SETTINGS and then press IRIS+ to enter the
window blank settings menu. Refer to Figure 3.3.21. A purple smear window will appear on the screen (the color of window
varies depending on camera models).
2. Follow the instructions that appear on the screen. Use the joystick or direction buttons to move the window to the desired
location.
3. Press FOCUS+ to start the setting of window blank size. Use the joystick or direction buttons to adjust the size of window
blanking area. After completion, press IRIS+ to save settings, and the window color will turn to gray.
The tilt range for configuring the window blank area is from 0~70°.
Note:

CLEAR WINDOW
Enter the CLEAR WINDOW menu to delete the current window blank.

3.3.9 AUX

An auxiliary output is a configurable signal from the dome back box that can trigger another device to operate. Refer to Figure 3.3.22
for the AUX settings menu.

AUX NUMBER
Select AUX1 through this item.

AUX MODE
It is used for defining alarm output type. Available settings include ALWAYS OPEN (default) and ALWAYS CLOSE, which
correspond to normally open and normally closed respectively.
<PRIVACY MASK>
1
DISABLE
BACK EXIT
Figure 3.3.20
Figure 3.3.22
SET WINDOW POSITION
FOCUS+SWITCH CONTENT
IRIS+ OK
IRIS- CANCEL
Figure 3.3.21
22