System Info Settings - HIKVISION DS-2DF5284-A User Manual

5 Inch Network High-definition Speed Dome User Manual

3.3.1 SYSTEM INFO SETTINGS

The SYSTEM INFO SETTINGS menu is used for setting the soft address, date and time, display information, etc. Refer to Figure
3.3.3 and Figure 3.3.4.

SOFT ADDRESS
When the ENABLE SOFT ADDRESS option is set to ENABLE, the speed dome will use the soft address, and the addresses from 1 to
255 selectable. Please note the dome address range supported by the current control keyboard. When the ENABLE SOFT ADDRESS
option is set to DISABLE, the address set by DIP switch is used. When the address is set to 0, the dome is capable of receiving the
control command from the control device of any address; when the address of the control device is set to 0, then the speed dome of any
address can be controlled as well. Refer to Figure 3.3.3.
SOFT ADDRESS
ENABLE SOFT ADDRESS DISABLE
<DATE AND TIME>
<ZERO POINT SETTING>
<DISPLAY SETTINGS>
<IP ADDRESS>
NEXT PAGE

DATE AND TIME
The DATE AND TIME allows user to set the date and time of the dome. As shown in Figure 3.3.5, the message indicates the current
date and time is 14:39:17 on December 30
Use the Left and Right buttons to select the option, and click the Up and Down buttons to modify the value.

ZERO POINT SETTING
Enter the ZERO POINT SETTING menu and then use the direction buttons to define the amount of pan from zero degrees vertical and
the amount of tilt from zero degrees horizontal, and finally press the Iris+ button to save settings and exit the current menu.

DISPLAY SETTINGS
The DISPLAY SETTINGS menu is displayed in one page, as shown in Figure 3.3.6.
Each item can be set with the separate display time on screen from 2sec, 5sec and 10sec selectable, or set to be ON or OFF. The preset
display position can overlapped the display positions of azimuth/elevation and zoom. If both of the ZOOM SHOW and the PT SHOW
are set to ON, then in the preset operation status, the preset label will be displayed all the time; while in other operation status, the
<SYSTEM INFO SETTINGS>
0
BACK EXIT
Figure 3.3.3
Y. M. D.
H. M. S.
IRIS+OK
IRIS- CANCEL
Figure 3.3.5
th
,2009.
<SYSTEM INFO SETTINGS>
POWER LOSS POSITION DISABLE
REBOOT PERIOD DISABLE
PT ADJUST PERIOD DISABLE
BACK EXIT
Figure 3.3.4
09 12 30
14 39 17
13