Installation And Preparation - JAI GO-5000M-PMCL User Manual

GO-5000M-PMCL / GO-5000C-PMCL
4.

Installation and preparation

Before starting operation, check to make sure that all equipment is appropriate and is connected in the
right manner.
① Lens
1-inch, C mount
1. Lens used
The GO-5000-PMCL employs a 1-inch CMOS imager. It is necessary to select a 1-inch C mount lens if the
full resolution of the camera is to be utilized. The imager used in the GO-5000-PMCL measures 16.392
mm diagonally, which is slightly larger than the standard 16 mm diagonal of the 1-inch format. Please
consult with your lens provider to select a 1-inch lens able to cover 16.392 mm, otherwise the image
captured may show vignetting.
It is possible to use C mount lenses with an optical format smaller than 1-inch, provided a less-than
full-resolution ROI is going to be used. For example, a centered ROI of 1920 x 1080 pixels (HD format)
will fit inside the image circle of most standard 2/3-inch C mount lenses. Likewise, a centered VGA ROI
(640 x 480 pixels) can be accommodated by a standard 1/3-inch C mount lens.
The rear protrusion on any lens used must be less than 10 mm.
The focal length of lens used is estimated by the following formula.
Focal length = ����/(1 + ��/��)
Here, WD: Working distance (the distance between lens and object)
W: Width of object
w: Width of sensor (the GO-5000-PMCL is 12.8 mm)
Connecting to PC
SDR type
Mini-CameraLink
SDR type
Mini-CameraLink
④ Camera Link Cable
- 9 -
② JAI SDK ③ Frame Grabber Board
MDR type
CameraLink
OR
SDR type
Mini-CameraLink