Activate The Remote Control; Watch The Tv Channels - BenQ VC3202 User Manual

6. Activate the remote control

Test your remote control
Press the power button (as shown in Fig left ). This shall turn
on the TV with the power indicator lights up in green. If succeed,
proceed to "7. Watch the TV channels" in Page 5.
If fail, fi rst check the power is available or not (The power
indicator should lights in orange).Second try to turn on the
TV by pressing the power button
on, the problem should be on the remote control. In this case,
please check the batteries and replace them with new ones if
necessary.
Press the power button on the TV or remote control once
again. This shall turn off and put the TV back to off mode with
the power indicator turn into orange.

7. Watch the TV channels

After tunning and saving the TV channels, you can watch the TV channels by following:
• Press the 频道 or 频道
or the CH - (Channel) or CH + (Channel) button on the TV to select the channel you
want to watch.
• Also can enter the channel number to select the channel directly. In this case you will
use the ten-keys on your remote control to enter the number. For example, just press
8 to select channel 8.
• If want to enter a double-digit channel number, fi rst press the Channel Entry button-/--,
then press the corresponding ten-keys buttons, For example, to select channel 28,
press the Channel Entry button-/-- and then 2, 8.
• The remote controll also provide you a shortcut to return to the previous channel. Just
press the 返回 button (as highlighted in Fig. left ), and the channel will be switched to
the previous one.
• Press the 音量+ or 音量- button on the remote control, or the VOL - or VOL + button
on the TV to adjust the volume. In this case, a volume indicator will be shown on the
screen.
For more informaion about this TV and its setup, please refer to this User manual.
This LCD TV has been designed to provide high resolution display.To obtain the best display
quality, connecting to a digital signal source is recommended. In this case, you shall set the
output resoultion of the source to match your TV resolution, and select a proper aspect ratio,
such as "4:3" or "Panorama" when you are watching traditional (analog) programs. For
more detaild information regarding the aspect ratio and how to set it, please refer to the
second part of this manual.
on the TV. If the TV turns
button (as highlighted in Fig. left ) on the remote control,
5