Installing The Control Horns - Pheonix Model Extra 330SC Instruction Manual

Instruction Manual
Collar
4. Tie the string from inside the wing to the end of
the servo wire. Pull the servo wire through the
wing with the string. Tape the servo wire to the
wing to prevent it from falling back into the
wing.
5. Temporarily position the aileron servo into the
servo bay. Drill a 1.6mm hole through the four
mounting holes of the servo, drilling through the
plywood mounting plate in the wing. Install and
remove a servo mounting screw into each of the
four holes. Insert a drop of thin CA into the
holes to harden the wood. After the glue has
cured, install the servo into the servo bay using
the hardware that came with your servo. Center
the servo and install a servo arm as shown.
3
4
Masking tape
5
↑
To the cowl
6. Repeat step # 1 - # 5 to install the second
aileron servo in the opposite wing half.

INSTALLING THE CONTROL HORNS

1. The aileron has a block wood plate for mounting
the control horn. One aileron control horn in
positioned on each aileron.
2. Remove the covering from the slot into the
aileron.
Remove the
covering
3. Install and secure the control horn using C.A
glue.
3
EXTRA 330SC
6
7
8