15kW INDOOR & OUTDOOR WOOD PELLET BOILER INSTALLATION, OPERATION AND SERVICING INSTRUCTIONS PLEASE NOTE: This product MUST be commissioned by a Trianco representative Please contact Trianco to arrange the commission immediately after install. Please read these instructions carefully before installing and operating this appliance TO BE RETAINED BY THE HOUSEHOLDER...
CONTENTS PAGE INTRODUCTION WARNINGS AND GAURANTEE / WARRANTY INFORMATION SAFETY INSTRUCTIONS OPERATING WARNINGS GAURANTEE / WARRANTY INFORMATION LIMITATIONS EXCLUSIONS PRE-INSTALLATION CONSIDERATIONS PELLETS CONSIDERATIONS FOR INSTALLATION OPERATING AREA CONNECTION TO THE FLUE OPERATING PROBLEMS CAUSED BY DRAFT DEFECTS IN THE FLUE 8 - 9 PLUMBING PROBLEMS INSTALLATION AND ASSEMBLY...
INTRODUCTION Dear Customer, We wish to thank you for choosing this Greenflame pellet boiler product from TR Engineering Ltd. In order to get the best performance from your appliance we recommend that you read this booklet carefully before lighting the appliance for the first time.
The appliance must be connected to an electrical system which is equipped with an earth conductor, as laid down in directives 73/23 EEC and 93/98 EEC. WARNINGS AND GUARANTEE / WARRANTY INFORMATION. The fuse must be of adequate rated capacity for the stated electrical power of the appliance.
Always keep the cover of the fuel hopper closed. OPERATING WARNINGS Keep this instruction manual carefully because it must stay with the appliance throughout its working life. If the Shut the appliance down in the event of a breakdown or appliance is sold or transferred to another user, always bad running.
GUARANTEE CONDITIONS booklet, especially those concerning warnings on the subject of installation, use and maintenance of the TR Engineering Ltd offers the following warranties on this appliance. appliance: Damage caused by transport and/or handling is excluded from the guarantee. Leaks in the heat exchanger – 5 years The guarantee will be invalidated in the event of damage caused by tampering with the appliance, atmospheric Faulty electrical components (motors, fan, controller) –...
Pre-Installation Considerations therefore lead to the termination of the guarantee and of the manufacturer's responsibility for the product. Pellets TR Engineering domestic pellet appliances run exclusively Wood pellets are manufactured by hot-extruding on pellets with a diameter of 6 mm. compressed sawdust which is produced during the working of natural dried wood.
CONNECTION OF THE FLUE A full range of straight, offset, elbow and ‘T’ elements is Where the appliance is to be installed indoors it is not available to overcome any obstruction which the flue permissible to install the appliance where another should avoid.
Page 9
Besides the direction and force of the wind, the position of the flue and the cowl with respect to the roof of the building and the surrounding landscape is important. The wind also influences the operation of the chimney IMPORTANT! indirectly by creating high-pressure and low-pressure The operation of the pellet boiler is noticeably sensitive zones, not only outside the building but inside as well.
INSTALLATION AND ASSEMBLY UNPACKING IMPORTANT! The GREENFLAME 15 Pellet Boiler will come packaged on a single pallet. The flue will be packaged separately. The connection of the boiler to the plumbing system must be carried out ONLY by specialized personnel who are...
The Greenflame pellet boiler should be positioned on a concrete plinth at least 50mm high and should project a minimum 100mm beyond the sides and the rear of the appliance and at least 600mm to the front.
The Greenflame boiler must be supplied with a 230V 50 Hz electrical supply via a two pole isolation switch rated for Overvoltage Category III and protected with a 6A circuit breaker.
BOILER CONTROL PANEL SCHEMATIC Only authorised TR Engineering personnel may open the control board. Any tampering with the PCB will immediately invalidate the warranty.
WATER CONNECTIONS A non-return valve should be fitted to prevent back- siphonage. The diagram below indicates the plumbing connections at the rear of the boiler. The return connection is factory Once the plumbing has been completed the system should fitted with a 25/6 Standard pump be fully flushed to clear any debris which may have become lodged in the pipe work.
CONTROL SYSTEM FUNCTION DESCIPTION BUTTON Function: Ignition, Extinguishing by pushing the button for 3 ON / OFF seconds until the acoustic signal. Function: Unblock. When the system is in Block by pushing UNBLOCK the button for 3 seconds until the acoustic signal. MODIFY VALUES INTO MENU In modify mode change menus and submenus values.
Page 17
ERRORS DESCRIPTION DISPLAY Error activation safety thermostat high voltage. Er01 Error activation pressure switch (only with the exhaust fan on). Er14 Accidental extinguishing for low exhaust temperature. Er03 Water over-temperature. Er04 Exhaust over-temperature. Er05 Encoder error. Er07* Error can occur for lack of encoder signal. Encoder error.
ERROR CODES In the unlikely event that the appliance fails to start or shuts down unexpectedly, then the Error code show on the display will give an indication as to the potential cause of the problem. Some of the errors can be cleared by the house holder and they are.
Page 19
BOILER OPERATION & MAINTAINANCE The Greenflame has been developed to ensure that the user is able to carry out the most basic functions in a safe When the combustion chamber door is opened, even and convenient manner. Once the installation has been...
Page 21
The secondary ash pan is located under the main emptied. A daily check during the first few days of combustion chamber. This needs to be emptied less operation will give an indication as to when it needs to be frequently. emptied.
TECHNICAL DATA Technical data GREENFLAME Nominal output 4.8 – 16.1 Nominal Fuel Input Kg/hr 1 – 3.5 Efficiency nominal Output (EN 303-5) 90.7 Smoke Temperature at Nominal Power °C 130 - 150 Smoke Temperature at Reduced Power °C 70 - 90...
BOILER HANDLING One of the key features of the E-Compact 15 is its size and ability to be transported to and located in confined spaces. Care should also be exercised when manoeuvring the appliance into position. The illustration below indicates the weight distribution of the appliance.
SERVICE LOG DATE SERVICE PROVIDED SERVICE ENGINEER DATE SERVICE PROVIDED SERVICE ENGINEER DATE SERVICE PROVIDED SERVICE ENGINEER DATE SERVICE PROVIDED SERVICE ENGINEER DATE SERVICE PROVIDED SERVICE ENGINEER DATE SERVICE PROVIDED SERVICE ENGINEER DATE SERVICE PROVIDED SERVICE ENGINEER...
Need help?
Do you have a question about the 15W Pellet Boiler and is the answer not in the manual?
Questions and answers