Table of Contents
Advertisement
IMPORTANT: Only qualified personnel should service internal components or electrical wiring.
WARNING: If repairs are to be made to the beverage system, remove quick disconnects
from the applicable product tank, then relieve the system pressure before proceeding. If
repairs are to be made to the CO
relieve the system pressure before proceeding. If repairs are to be made to the ice dispensing
system, make sure electrical power is disconnected from the unit.
Trouble
NOTE:
should your unit fail to operate properly, check that there is power to the unit and that the
hopper contains ice. If the unit does not dispense, check the following chart under the
appropriate symptoms(s) to aid in locating the defect.
BLOWN FUSE OR CIRCUIT
BREAKER.
SLUSHY ICE. WATER IN
HOPPER
BEVERAGES DO NOT
DISPENSE.
BEVERAGES TOO SWEET.
BEVERAGES NOT SWEET
ENOUGH.
BEVERAGES NOT COLD
(UNITS WITH BUILD-IN COLD
PLATE).
NOTE: Contact your local syrup or beverage equipment distributor for additional information and
trouble shooting of beverage system.
NO ICE DISPENSED FROM
ICE PORTION CONTROLLER
TROUBLESHOOTING
system, stop dispensing, shut off the CO
2
Probable Cause
A.
Short circuit in wiring (115V
circuit).
B.
Defective agitator motor.
A.
Blocked drain.
B.
Unit not level.
C.
Poor ice quality due to water
quality or ice maker problems.
D.
Improper use of flaked ice.
A.
No 24 volt power to faucets.
B.
No CO
pressure.
2
A.
Carbonator not working.
B.
No CO
pressure in
2
carbonator.
C.
Faucet brix requires adjusting.
A.
Empty syrup tank.
B.
Faucet Brix requires adjusting.
A.
Unit standing with no ice in
hopper - no ice in cold plate
cabinet.
A.
Insufficient ice supply in ice
bin.
B.
Ice in ice bin bridged (stuck
together).
C.
No electrical power to
dispenser.
11
supply, then
2
Remedy
A.
Replace defective wiring.
B.
Replace agitator motor.
A.
Open–up/flush out drain.
B.
Level unit.
C.
Install water filter system. For
Icemaker problems, consult
icemaker manual.
D.
Replaced flaked ice with "cube
style ice (see page 2, Unit
Description).
A.
Check that beverage switch is
"on". Check 24V transformers.
B.
Check CO
regulator. Check CO
2
tank pressure.
A.
Check carbonator.
B.
Check CO
regulator. Check CO
2
tank pressure.
C.
Brix Faucet.
A.
Refill syrup tank.
B.
Brix Faucet.
A.
Refill hopper with ice.
A.
Replenish ice supply as required.
B.
Gently tap on ice to break it loose.
C.
Plug in dispenser power cord, or
check fuse or circuit breaker.
2
2
620919541
Hide quick links:
Advertisement
Table of Contents
