Filling Or Re-Filling The Water Reservoir - Russell Hobbs RHCM50 Instructions And Warranty

Blue Light in
the Used
Capsule
Container/ Bin

FILLING OR RE-FILLING THE WATER RESERVOIR

Before using this appliance for the first time or after long periods of not operating the appliance, the
machine must be rinsed out. This short procedure will rinse and clean the internal piping
thoroughly.
First note that there are two ways to fill the water reservoir: directly into the water reservoir by
using for example a jug or by removing the water reservoir from the appliance.
Filling without removing the water reservoir:

Lift the water reservoir lid

Fill the water reservoir up to the "MAX" level
mark with cold fresh water (the maximum
capacity is 0.8 litre), or fill at least the "MIN" level
mark as shown in figure 1.

Lower and close the water reservoir lid
Solid/ steady control
panel lights.
Each control panel
button appears to
flash in a circular
pattern/ fashion.
The blue capsule
container/ bin light is
solid/ steady for visual
checking when the
operating handle is
open.
Ready.
In energy-saving mode.
Check if the used capsule
container/ bin is full.
Figure 1.
12