Connecting A Data Terminal Or A Printer To The Vps - Panasonic KX-TVP150 User Manual

2.2.3 Connecting a Data Terminal or a
Printer to the VPS
RS-232C parameters
Connecting RS-232C
cable
Note:
For the system administration (system set-up, mailbox set-
up, and system diagnosis), the RS-232C terminal must be
connected to a serial interface (EIA port) of the unit. If the
DEC VT220 (100) or VT220 (100) compatible terminal is
used, the System Administrator can set up system param-
eters and diagnose the system with the conversational
menu-driven program. Other RS-232C terminals can be
also used.
If you wish to output reports and the like to a printer, it
must first be connected to the system using an RS-232C
cable. The wiring and parameters are the same as those for
a terminal. If you set print time by using the PSET Utility
Command, various system usage reports can be printed via
a printer connected to the EIA port (Refer to 3.3.5 Utility
Command). The communication parameters of the unit
have been set to the following values at the factory.
- Baud Rate: 9600 bps
- Word Bit Length: 8 bits
- Parity: None
- Stop Bit Length: 1 bit
Before connecting the cable, make sure the power switch
on both data terminals and the VPS system is OFF.
Data terminal
or Printer
1
Insert the RS-232C cable into the VPS with the connector
indicating the same direction.
Managevs
Guide
Configuration & Installation
M-2- 17