Panasonic KX-TVP150 User Manual page 47

3.3.1 Hardware Settings
A value "A" is used to disconnect a line connected to the
VPS automatically after transferring a call to an extension.
When using a value "A", set it after X as follows:
FWWXA.
When the Inband Integration is utilized, set this sequence
to "FTX."
Extension Transfer
Sequence
The extension transfer sequence is similar to the operator
transfer sequence. It is executed by the VPS before dialing
any extension other than the operator's, and has the same
letters, dial codes and factory settings as the operator
transfer sequence.
'
When the Inband Integration is utilized, set this sequence
to "FTX."
Reconnect Sequence from
Busy
If the extension that a caller wants is busy, this function
allows the VPS to reconnect with the caller. It is pro-
grammed by the System Administrator using the same let-
ters and dial codes as the transfer sequence. It is set to
'FWW' (Flash, Wait for 2 seconds) at the factory.
Reconnect Sequence After
a No-Answer Call
If the extension that a caller wants does not answer, the
Reconnect Sequence allows the VPS to reconnect with the
caller. It has the same letters, dial codes, and factory set-
ting as the Reconnect Sequence from Busy.
:. :,
':
Reconnect Sequence on
Refuse Call
Light-On Sequence for
Message Waiting Lamp
This Reconnect Sequence is used if the extension the caller
wants is off the hook and neither the [l] (answer the call)
nor the [2] (otherwise) key has been pressed. It has the
same letters, dial codes, and factory setting as the Recon-
nect sequence from Busy.
This is the dialing sequence that the VPS must perform to
cause the PBX to turn on the waiting lamp on an exten-
sion.
The light-on sequence for the message waiting lamp has the
same letters and dial codes as the transfer sequence. It is set
to 'W7OlX#' (Wait for 1 second- Dial 701, Extension and
w*
Manager's Guide
System Administrator
M-3- 11
(1292-G)