Table of Contents
Advertisement
3.3.1 Hardware Settings
The hardware settings:
-
-
-
-
3.3.1.1 RS-232C
Baud Rate
Word Bit Length
Parity
Stop Bit Length
For system administration
(system set up, mailbox set up,
and system diagnosis), the RS-232C terminal must be con-
nected to a serial interface of the VPS unit. The communi-
cation parameters of the unit are set at the factory to these
values.
RS-232C (See 3.3.1.1)
Telephone Line Port (See 3.3.1.2)
Silence Reduction (See 3.3.1.3)
PBX (See 3.3.1.4)
The baud rate is set to 9600 bits per second at the factory,
but can also be set to 150, 300, 600, 1200,2400,4800, 9660
and 19200.
The word bit length is set to 8 bits at the factory but can
also be set to 7 bits.
The parity is set to 'NONE' at the factory, but can be set
to 'EVEN' and 'ODD'.
The stop bit length is set to 1 at the factory but can be set
to 2.
3.3.1.2 PBX Telephone Line Port
The VPS must be connected to a PBX telephone line port
before system start up of which there can be a maximum
of eight connections.
Hook switch Flash
Timing
The hook switch can be used to transfer callers to an atten-
dant or other extensions. The hook switch flash timing is
the duration of the hook flash for call transfer. It is set to
600 msec at the factory but can be set to 300 and 900
according to the type of PBX parameter setting.
,
Manager 's Guide
System Administrator
M-3-7
Advertisement
Chapters
Table of Contents
