Pit Boss PB340 Owner's Manual page 9

Section One:
Parts Needed:
Hardware Required:
Screw 1/4"- 20* 1/2" x 2 (A)
Installation Steps

Insert one screw (A) from inside the lid, through the hole
provided in the lid.

Place one insulation washer, then a Bezel (6) and finally
another washer over the screw, then line-up the handle
(5) with the threaded end of the screw.

Hand start the screw into the handle,

Repeat procedure for other end of handle.

Using your wrench securely tighten ALL screws (A)
Part Needed:
Dome Thermometer
Installation Steps

The thermometer comes complete with its own threaded nut
already installed on the thermometer.

Simply spin off the threaded nut, and insert the thermometer
through the hole provided in the top of the hood,
Then firmly hand tighten the nut back onto the thermometer.
Note: Take care not to turn the face of the thermometer. This
will result in incorrect readings.
ASSEMBLY INSTRUCTIONS
ASSEMBLING THE LID HANDLE
16 1 x Stainless Handle
17 2 x Decorative Bezel
4 x Insulation Washers
ASSEMBLING THE DOME THERMOMETER
Page 9