Fujitsu M3096NT Operator's Manual page 138

Problem Possible cause
The check The carrier fixing bracket
indicator is on. was not removed.
——————————
"Please clean The pick roller is dirty.
Pick-roller" is
displayed on the
operator panel
during the read
operation in the
ADF.
The unallowable document
Or check
was read in the automatic
indicator blinks
document feeder.
at four seconds
(See Section 5.3.)
period.
Paper double feed Pad is dirty.
Pad is worn out.
Miss pick Pick roller is dirty.
Pick roller is worn out.
Paper jam Some foreign particles are in
ADF.
Network does HUB unit is not power-on.
not respond. (10BASE-T)
Terminator is not attached.
* Please chack the test mode in appendix B, if possible, before calling the service representa-
tive and inform status of the indicators.
7 – 2
Table 7.1 Check items (continued)
Response
Remove the carrier fixing bracket as
explained in Section 3.2, "Removing the
Carrier Fixing Bracket."
Turn the power off then on again. If the
check indicator turns on again, contact the
sales person in charge or a Fujitsu service
representative.*
When the power is turned off, the mes-
sage is cleared.
Even if the message is displayed, the read
operation can be continued. Clean the
pick roller after the read operation.
(See Section 6.3.2.)
If a document not meeting the scanner
specifications is read in the automatic
document feeder, the document is not fed
smoothly and an error message may be
displayed.
Read the document in the flat bed station.
Clean the Pad. (See Section 6.3.2)
Replace the pad. (See Section 6.4.2)
Clean the Pick roller. (See Section 6.3.2.)
Replace the Pick roller.
(See Section 6.4.3)
Clean the ADF (See Section 6.3.2) or
remove any foreign particles.
Turn-on the HUB unit.
Attach the terminator.