Overview Of Initial Setup Operations - Alaxala AX6300S Quick Start Manual

3. Required Operations When Installing a Switch

3.2 Overview of initial setup operations

An overview of the operations necessary when installing a Switch is described
below.
For detailed operations, see the subsequent sections.
NOTE
(1) Login
Log in to the Switch. Use the initial user ID, which is
password is not set for the
(2) Setting the administrator mode password
Use the
enable
the initial installation, this password has not been set. To ensure security, set a
password for administrator mode.
(3) Adding a user ID and deleting the operator user ID
Create a new user ID.
If you will no longer use the operator login user ID, which is set in the initial
installation as the login user name, we recommend that you delete it after creating a
new login user with the
NOTE
(4) Setting the time
Set the time zone and the time. When a Switch is initially installed, the time has not
been set. Since time is critical information for gathering fault information, set the
exact time.
20
Below is the minimum number of operations necessary for installing a Switch.
For operations after the initial operations, see the manuals listed in 4.1
Operation management and configuration settings.
operator
command to specify a password for entering administrator mode. In
command. Doing so strengthens security.
rmuser
If you forget your user ID, you will not be able to log in.
Do not forget your user ID.
operator
user, you can log in without authentication).
(Because a