Alaxala AX6300S Quick Start Manual page 20

Safety Information
Do not turn off the power of the Switch power while software is being
updated (while the
When the
not turn off the Switch until it has been restarted (when the STATUS LED on the
management and switching unit changes from blinking green to constant green).
Doing so could result in a Switch failure.
When the ACC LED is lit, do not remove the memory card or turn off the
power.
When the ACC LED on the front panel of the management and switching unit is lit,
the memory card is being accessed. When a memory card is being accessed, do
not remove the memory card or turn off the power. Doing so might damage the
memory card. In addition, some commands require a certain amount of time after
being entered to finish accessing the card. Make sure that the memory card is no
longer being accessed before removing the card or turning off the power.
Handle memory cards carefully.
When inserting a memory card, do not push the card too strongly or flick it with your
finger. When removing a memory card, do not forcibly pull out the card if it is locked.
Doing so might damage the connector of the memory card slot.
Remove the memory card before moving the Switch. If a card is subjected to
excessive force when the Switch is moved, the connectors on the memory card slot
might be damaged.
Do not attach any labels to a transceiver.
A label attached to the transceiver indicates that the transceiver is a standard
product from ALAXALA or another manufacturer. However, such labels are attached
where they do not interfere with heat dissipation from the transceiver or the
mechanism that prevents the transceiver from coming loose from the cage.
Attaching a label to a location that interferes with these functions could cause a
malfunction in the transceiver or damage to the Switch.
For power supply facility, avoid voltage drop caused by inrush current.
When a Switch is turned on, current flows in. Consider measures for avoiding a
voltage drop in the power supply facility caused by the incoming current. Voltage
drops affect not only the Switch, but also the devices connected to the same power
supply facility.
Turn off the power before connecting or disconnecting the power cable.
Before connecting or disconnecting a power cable, set the power switch of a power
supply unit to OFF.
Safety-12
command is being executed).
ppupdate
command is executed, the Switch restarts automatically. Do
ppupdate