Spray Patterns; Plugged - Titan Speeflo Hydra M 2000 Owner's Manual

condition
A. Tails
B. Hour glass
C. Distorted
D. Pattern expanding and contracting
(surge)
E. Round pattern.
© Titan Tool Inc. All rights reserved.
Troubleshooting - Spray Patterns
Possible cause
Inadequate fluid delivery.
Fluid not atomizing correctly.
Inadequate fluid delivery.
Plugged or worn nozzle tip.
Suction leak.
Pulsating fluid delivery.
Worn tip.
Fluid too heavy for tip.
13
correction
Increase fluid pressure. Change to small
tip orifice size. Reduce fluid viscosity.
Reduce hose length.
Clean gun and filter(s). Reduce number of
guns using pump.
Same as above.
Clean or replace nozzle tip.
Inspect for siphon hose leak.
Change to a smaller tip orifice size.
Install pulsation dampener in system or
drain existing one. Reduce number of
guns using pump.
Remove restrictions in system, clean tip
screen if filter is used.
Replace tip.
Increase pressure. Thin material. Change
nozzle tip.