Using Mod. Dynamic -Matic - Classic - Unox XFT LineMiss Instruction Manual

Using mod. Dynamic - Matic - Classic
The LineMiss™ models are used by pressing the screen-printed keypad.
Press only with fingers and no other objects, such as knives, forks, etc...
durability and avoiding any type of mechanical failure.
The LineMiss™ models can be used in MANUAL or PROGRAMMED mode.
MANUAL mode requires the user to set the parameters listed in the table for each cooking cycle; these param-
eters are NOT saved and must be input for each successive cooking cycle.
Cooking Parameters
Dynamic - Matic Models
cooking time
Operation in PROGRAMMED mode allows one program to be saved for use during successive cycles.
Each program contains 4 phases:
- PHASE 1: initial pre-heating;
- PHASES 2 ->4: up to 3 cooking steps, each characterized by different cooking parameters. Cooking does not
necessarily require all three STEPS: set only those required.
EXAMPLE OF SETTING A COOKING CYCLE
cooking
parameters
-
PRE-HEAT 180°C
-
- When the oven is connected to the power supply, the control panel switches on automatically.
- Button functions
-
mains lit. Simply press the
English
OK
STEAM.Plus
cooking
parameters
1h:30 min
STEP 1 200°C
20% steam
:
button to reactivate the electronic controls.
22
Classic Models
cooking time
oven cavity temperature
not present
cooking
parameters
30 min
STEP 2 100°C
60% steam
RANGE
STEP 3 not used
LED re-