Attaching A Sync Cord To The Housing - Ikelite 6951.07 Instruction Manual

Attaching a Sync Cord to the Housing -

3. Line up the Sync Cord Pins with the corresponding Bulkhead
Receptacles. Gently insert Sync Cord into Bulkhead. DO NOT force this
installation. If the Sync Cord does not seat properly inside the Bulkhead,
then the Pins and Receptacles are improperly aligned (repeat Step 3).
4. Tighten the Knurled Nut snugly using your Index finger and thumb. DO
NOT use pliers or other tools to tighten the Knurled Nut.
-
Always remove the Sync Cord from your Housing when not in use and
replace the Bulkhead Cap.
Knurled Nut
Sync Cord O-ring
Sync Cord Pin
Housing
Bulkhead
16
Diagram F
continued
Ikelite TTL
Sync Cord
Bulkhead
Cap