Entering The Water; Removing The Camera From The Housing - Ikelite 6951.07 Instruction Manual

Entering the Water

As soon as you enter the water, take a moment and check to see that
the housing is properly sealed. We recommend you first water test the
housing with no camera inside to assure a safe and watertight
environment.
Next, check to see if there are any bubbles on the face of the lens port.
If there are, take your finger and remove them. If there are bubbles on
the lens port they can produce soft focus spots in your photos or video.

Removing the Camera from the Housing

1. Thoroughly dry housing.
2. Remove the housing back, see Opening the Housing, Step 3, Page 9.
3. Remove the Hotshoe from the camera mount.
4. Place your index finger over the top of the Tray Removal Screw and
gently pull backward to separate Mounting Tray and camera from
housing. Continue pulling Mounting Tray backward while holding the
camera with your other hand; remove from housing.
If you are finished using the housing, remove the Mounting Tray from
the camera bottom and slide it back into the Housing Mounting Plate.
For storage and travel,
remove the back o-ring
and place in a small
plastic bag. Place the
bag inside the housing
and re-attach the
housing back.
Note: The Mounting
Tray might need to be
removed when
changing a camera
battery or memory
card.
14
Diagram E
Optional MIL Dome Port 5516.15