Attaching A Sync Cord To The Housing - Ikelite 6970.07 User Manual

Attaching a Sync Cord to the Housing

The Housing Bulkhead is designed to accept sync cords with Ikelite 5
pin/receptacle connector fittings.
1. Lightly lubricate the Sync Cord O-ring. Use ONLY Ikelite lubricant
(supplied with housing).
2. Remove Bulkhead Cap from Housing Bulkhead.
3. Line up the Sync Cord Pins with the corresponding Bulkhead
Receptacles. Gently insert Sync Cord into Bulkhead. DO NOT
force this installation. If the Sync Cord does not seat properly
inside the Bulkhead, then the Pins and Receptacles are
improperly aligned (repeat Step 3).
4. Tighten the Knurled Nut snugly using your Index finger and thumb.
DO NOT use pliers or other tools to tighten the Knurled Nut.
- Always remove the Sync Cord from your Housing when not in use
and replace the Bulkhead Cap.
Diagram F
Knurled Nut
O-ring
Sync Cord Pin
Housing Bulkhead
Ikelite TTL Sync Cord
Bulkhead Cap
17