Table of Contents
Advertisement
AM8010 Precision Thermometer User's Guide
8 Sensor Connector Assembly and Pin
Configuration
The sensor connector is a 5-pin round connector with retention
relief. The assembly drawing is shown in the following figure.
Figure8-1: sensor connector assembly drawing.
The pin configuration of the connector is shown as in Figure 8-2.
3
4
2
1
5
Figure 8-2: Rear view of the 5-pin connector.
There are 5 pins on the connector. For a 4-wire platinum sensor,
pin1 and pin2 should be one end of the sensor, and pin4 and
pin5 should be another end of the sensor. Pin3 cab be optionally
connected to cable shield or left open. One example of pin
configuration is shown in the following
Error! Reference source not
.
found.
30/33
Advertisement
Table of Contents
