Table of Contents
Advertisement
AM8010 Precision Thermometer User's Guide
enough power. It is suggested to use new batteries for
parameter setting or calibration.
2. Set the Mode Switch to Measurement Mode. Refer to
4.1Mode switch setting.
3. Power on AM8010. If a sensor is connected to AM8010，
the LCD should display the measurement reading. See the
flowing figure as an example. If no sensor is connected
users can still set parameters of a sensor.
4. Press and hold
down corner of LCD should show "MENU".
t=
27.0956
Rt = 110.6500
t = 80.772
Then hold the
finger. AM8010 should enter into adjustment program.
5. Followings will be displayed on LCD after step 4. If no
adjustment or setting is needed, press
move the highlight line to"EXIT" and then press
key，AM8010 will go back to measurement mode.
SENSOR SETTING
6. Move the highlight line to "SENSOR SETTING" and
press
key to adjust sensor's settings. Followings will
be displayed：
MENU
key for more than 3 seconds，the right
MENU
key and press the
* MAIN MENU
EXIT
Enter = Yes
IPRT
C
OHM
F
MENU
key with another
or
key to
19/33
Advertisement
Table of Contents
