Table of Contents
Advertisement
AM8010 Precision Thermometer User's Guide
"PRT" on the LCD near the end of the first line. Users
can configure the sensor type by following the
procedures that are detailed in Chapter 6 "Sensor
Parameter Input/Adjustment". "IPRT" is defined as a
100
sensor with temperature coefficient α=0.00385.
Ω
"PRT" is defined as a 100
temperature coefficient α=0.003925 (W
5. "NO SENSOR" status. "NO SENSOR" will be displayed
when no sensor is connected to AM8010.
6. "LOW BAT" status. "LOW BAT" is displayed when the
batteries are low in power.
The second line shows the measured results with larger fonts to
help users to focus on the key readings. The information of
second, third and fourth line can be scrolled up or down based
on user's preference.
4.7 TOUCHPAD operating
There are four touch keys on AM8010 front panel. These touch
keys are used for scrolling up/down measurement data, or for
sensor parameter adjustment and calibrations.
Note: These keys are not mechanical push button. They are only
sensitive to finger touch.
When the meter is set to Measurement Mode
user to choose scroll up/down the measured readings in Celsius
(C), Fahrenheit (F) and sensor resistance (OHM).
MENU
and
keys can be used for sensor type selection and sensor
parameter adjustment. These two keys are also used in
Calibration Mode (see Chapter 6).
SPRT/PRT with
Ω
≥1.11807).
Ga
and
are for
11/33
Advertisement
Table of Contents
