Alcatel-Lucent OmniPCX Office Installation Manual page 83

Note:
In dynamic (DHCP) mode,8002/8012 Deskphone sets are fully plug & phone. This operation is not
mandatory.
To create an 8002/8012 Deskphone:
1. In OMC, go to Users/Base stations List.
2. Select a No., IP access and click the Add button.
3. Select IP terminal and click OK.
4. Select the newly created user in the list, select 8002 DeskPhone/8012 DeskPhone in the
combo box type and enter a name.
5. Click the Modify button.
6. Double-click the newly created user to open the User dialog box.
7. Click the IP/SIP button and enter the MAC address of the set in the IP Parameters tab.
8. If needed, in the SIP Parameters tab, click the SIP password reset button to get a new
password.
Connecting the set
This section describes how to connect an 8002/8012 Deskphone set to the LAN (Local Area
Network).
To connect the set to the LAN:
1. Plug an RJ45 cable between the set LAN connector and a port of the switch
Accessing the set administration menu
1. Connect the set to the LAN
2. During set initialization (steps 1/5 to 5/5) , press the *, then # keys
If the set password is required, enter the set password and press OK
As sets do not come with an alphabetic keyboard, use the numeric keypad to type the
password:
a. For each letter, press the key on which the corresponding letter is printed
Example:
For alcatellucent enter: 2522835582368
b. Once the full password is entered, press the OK key
The set administration menu is displayed.
Note:
When the set is started, the administration menu is available from the Settings > Admin Settings menu.
Initializing the sets
The following paragraphs describe how to:
- Select the initialization type
- Initialize the 8002/8012 Deskphone set
Selecting the initialization type
4-35