Sip Terminals; 8002/8012 Desk Phone - Alcatel-Lucent OmniPCX Office Installation Manual

Chapter
4
- Audio test
If this sequence is correct, the display on the dedicated terminals shows the system date:
Monday 01 January 00h00.
After powering up, you can activate the system from a dedicated terminal or by OMC (refer to
the specific notice).
4.4

SIP Terminals

4.4.1

8002/8012 Desk Phone

4.4.1.1 Commissioning
4.4.1.1.1 Overview
This module presents all the actions required for commissioning the 8002/8012 Deskphone
sets.
4.4.1.1.2 Commissioning the set
This section describes how to commission the set in the two available initialization options:
- Static initialization: commissioning is manual on the set and through OMC
- Dynamic initialization (DHCP): no commissioning is needed, 8002/8012 Deskphone sets
are fully plug & phone
Depending on the selected mode, the set commissioning is different.
For static initialization, the operation order is as follows:
1. Configure the user in OMC, refer to:
2. Connect the set, refer to:
3. Configure network parameters on the set, refer to
For dynamic initialization, the operation order is as follows:
1. Configure the DHCP Server, refer to
2. Configure the user name and password in OMC, refer to
password in OMC
Prerequisites
- The Alcatel-Lucent OmniPCX Office Communication Server version must be R9.0 or
higher and the system must be operational
- For network configuration, any of the following must be implemented:
• In dynamic mode, a DHCP server must be configured
• In static mode, a free IP address must be available for the set
- A port with PoE must be available on a switch. If not available, a PoE injector or a specific
Power Adapter must be used
Configuring the user in OMC
4-34
Configuring the user in OMC
Connecting the set
Configuring the DHCP server for dynamic initialization
Commissioning the Set in Static Mode
Configuring the user name and