Alcatel-Lucent OmniPCX Office Installation Manual page 100

Chapter
4
2. Plug the RJ45 cable into the set's LAN connector.
3. Connect the RJ45 cable to the LAN.
Initializing the sets
This section describes how to:
- Select the initialization mode
- Initialize the 4135 IP Conference Phone set
Selecting the initialization type
The default initialization is dynamic.
To select the initialization type, refer to the table below.
If
You have a DHCP
server
You do not have a
DHCP server
Configuring the DHCP server for dynamic initialization
In Dynamic initialization (default value), the set selects the first DHCP offer, with a Vendor
Specific option corresponding to an Alcatel-Lucent server.
When initializing in dynamic mode, the set provides the following information in the DHCP
Discover message:
- Option 60: (vendor class identifier): alcatel.sip.0
- Option 55: list of requested options: subnet mask, router option, broadcast address, option
43 vendor specific info, server ID, renewal time, rebinding time and vendor class ID
Option 43 is vendor specific information, meaning that this option is defined for a specific client
4-52
table 4.23: Initialization type selection
Then the required
initialization mode is
Dynamic or Proprietary
dynamic
Static
Further information
- Refer to Configuring the DHCP server
for dynamic initialization
- In the case of Proprietary dynamic
mode, the IP address of the set must be
provided by the Proprietary router.
- Refer to Configuring network parameters
for static initialization
- Obtain from your network administrator:
• An IP address for the 4135 IP
Conference Phone set
• The subnetwork mask
• The router address
• The DNS addresses (primary ans
secondary)
• The VLAN ID (if VLAN is used)
• The URL of the Alcatel-Lucent
OmniPCX Office Communication
Server for configuration files
download
Note:
You need to know the set directory number.