If
You have a DHCP server
You do not have a DHCP
server
Initializing the IP Touch set
To initialize the IP Touch set, refer to the table below.
For an
Procedure
initialization
that is
Dynamic mode
1. Connect the power supply.
or Proprietary
2. Before initialization phase 5 starts, press i, then the # key.
dynamic mode
3. If the set was previously in static mode, choose IP Parameters from the Main
4. Choose Dynamic.
5. Save by pressing the soft key in the upper left part of the display.
6. Exit the Main menu by pressing the soft key in the upper right part of the display.
Then the required
initialization mode is
Dynamic mode or
Proprietary dynamic mode
Static mode
table 4.29: Initialization procedure
The Main menu appears.
menu.
The IP Parameters menu appears.
And
Refer to
table: Initialization
procedure
In the case of Proprietary
dynamic mode, the IP address
of the set must be provided by
the Proprietary router.
-
Refer to
table: Initialization
procedure
-
Obtain from your network
administrator:
•
An IP address for the
IP Touch set
•
The subnetwork mask
•
The router address
•
The TFTP server
address, which is the
IP address of the
PowerCPU board
embedding the VoIP
board
Note:
You need to know your set's
directory number.
4-65