Seat Rotation - Pride Sundancer Owner's Manual

V I I . C O M F O R T
OPERATING YOUR POWER SEAT
1. Ensure your Sundancer is level and stationary.
2. Toggle on the power seat switch.
3. To raise the power seat, place your hands on the handgrips and use your thumb to push the right side of the
lever.
4. Release the lever when you have attained your desired height.
5. To lower the power seat, place your hands on the handgrips and use your thumb to push the left side of the
lever.
6. Release the lever when you have attained your desired height.
7. Ensure your seat is in the lowest position and toggle off the power seat switch before you attempt to drive your
Sundancer again.
FRONT-TO-BACK SEAT ADJUSTMENT
You can reposition the Sundancer’s seat forward or
rearward. See figure 12.
1. Remove the seat from your Sundancer. See VIII.
“Disassembly and Assembly.”
2. Use a 7/16” wrench to remove the seat position
adjustment screws.
3. Reposition the seat base on the seat and reinstall the
seat position adjustment screws.
4. Reinstall the seat.
ARMREST WIDTH ADJUSTMENT
The armrest width of your Sundancer can be adjusted
inward or outward. See figure 12.
1. Loosen the armrest adjustment knobs at the back
of the seat frame.
2. Slide the armrests in or out to the desired width.
3. Tighten the armrest adjustment knobs.
NOTE: The armrests also pivot upward to make
getting on and off of your Sundancer easier.

SEAT ROTATION

The seat lock lever locks the seat in one of four positions. See figure 12.
1. Push down on the seat lock lever to unlock the seat.
2. Rotate the seat to the desired position.
3. Release the seat lock lever to lock the seat securely in place. If the seat is not locked into position, gently rock
the seat back and forth until you hear the lever click.
Sundancer
A D J U S T M E N T S
ARMREST ADJUSTMENT KNOBS
SEAT POSITION
ADJUSTMENT
SCREWS
Figure 12. Seat and Armrest Adjustment
SEAT
LOCK
LEVER
23