Seat Rotation; Seat Height Adjustment - Pride Sundancer User Manual

V I I I . C O M F O R T A D J U S T M E N T S

SEAT ROTATION

The seat lock lever locks the seat in one of four posi-
tions.
1. Pull up on the seat lock lever to unlock the seat.
See figure 10.
2. Rotate the seat to the desired position.
3. Release the seat lock lever to lock the seat securely
in place.
FRONT-TO-BACK SEAT ADJUSTMENT
You can reposition the scooter’s seat forward or rear-
ward to one of three settings thereby adjusting the dis-
tance between the seat and the tiller. See figure 10.
1. Remove the seat from your scooter.
2. Remove the four bolts that fasten the seat to the
seat platform. See figure 10.
3. Align the seat platform with the desired set of holes
on the seat.
4. Replace and tighten the four bolts securely.
ARMREST WIDTH ADJUSTMENT
The scooter armrest width can be adjusted inward or
outward.
1. Loosen the armrest adjustment knobs at the back
of the seat frame. See figure 10.
2. Slide the armrests in or out to the desired width.
3. Tighten the armrest adjustment knobs as required.
The armrests can also be lifted upward to aid in getting
onto and off of your scooter.

SEAT HEIGHT ADJUSTMENT

The seat can be repositioned to three different heights.
See figure 11.
1. Remove the seat from your scooter. See IX. “Dis-
assembly and Assembly.”
2. Use the attached ring to pull and remove the detent
pin from the lower seat post.
3. Raise or lower the upper seat post to the desired seat height.
4. While holding the upper seat post at that height, match up the
adjustment holes in the upper and lower seat post.
5. Fully insert the detent pin.
6. Replace the seat.
Sundancer
ARMREST ADJUSTMENT KNOBS
BOLTS
FIGURE 10. SEAT ADJUSTMENTS
UPPER SEAT POST
ADJUSTMENT HOLES
DETENT PIN
LOWER SEAT POST
FIGURE 11. SEAT HEIGHT ADJUSTMENT
SEAT LOCK LEVER
29