Table of Contents
Advertisement
CLEANING AND
MAINTENANCE
Continued
BULB REpLACEMENT
WARNING: The halogen light
bulbs in your unit can become
extremely hot. Allow at least 10
minutes between turning off the
heater and removing the light
bulbs to avoid accidental burns.
There are a total of 6 halogen light bulbs (type
GX6.35 rated 120 volts, 20 watts or 35 watts)
in your unit.
• 2 bulbs provide illumination for the ember bed
beneath the log set
• 2 bulbs provide illumination for the flame
generation assembly
• 2 bulbs for replacement
WARNING: Do not install
replacement bulbs that exceed
specified maximum watts.
Your fireplace unit must be opened in order to replace
the light bulbs. To reduce the number of times you
need to open the unit, replace all bulbs at the same
time. If the unit has been running, turn off power and
let fireplace cool before changing bulb.
Ember Bed Bulbs
1. Remove front face by removing screws. Screws
are located on the back side of the front face
around the outer edge (see Figure 7).
2. From the bottom, gently pull forward and lift
up log set ember bed until front edge clears
the front of the unit (do not pull up on logs).
3. Remove spring clip. Hold socket and pull out
the old bulb.
4. Hold socket and push in new bulb (DO NOT
exceed wattage).
5. Repeat steps 3 and 4 with second bulb. Recon-
nect spring.
Spring Clip
Figure 6 - Ember Bed Bulb Location
119719-01A
Bulbs
www.desatech.com
6. Gently push ember bed down until rear edge
is resting against rear ledge of unit.
7. Replace front face.
Flame Generation Bulbs
1. Remove front face by removing screws. Screws
are located on the back side of the front face
around the outer edge (see Figure 7).
2. Remove screws from glass holder brackets.
The brackets are located on the inside of the
fireplace and the screws to be removed are on
the outside (see Figure 7 for screw and glass
location).
3. With gloves on, lift up on bottom of glass
and pull forward. Place glass on smooth, soft
surface to avoid breakage.
4. Locate flame generation cylindrical drum,
Figure 8.
5. Squeeze half of drum cylinder until it's top
edge clears the top drum track. Remove bot-
tom edge of cylinder drum from bottom drum
track. This will give you access to the light
bulbs. Note: Do not exert excessive pressure
on drum cylinder as this may cause damage.
6. Remove spring clip. Hold socket and pull out
old bulb.
Figure 7 - Glass Bracket and Front Face
Screw Locations
Flame Cylinder Drum
Figure 8 - Flame Generation Cylinder
Front Face
Screw Locations
Glass Holder
Bracket Screw
Locations
Front Face
Screw Locations
Drum
9
Advertisement
Table of Contents
