Table of Contents
Advertisement
OPERATING
INSTRUCTIONS
Continued
OpERATING By REMOTE CONTROL
1. Plug in your electric fireplace.
2. Push the ON/OFF Power Button to turn
unit on. Power LED will light.
3. When operating the remote control, it must
be pointed at the sensor behind the louver.
Note: Make sure your batteries are fully
charged and installed correctly in your
remote control.
4. The ON/OFF button at the top left of the
remote is the main ON/OFF power button.
Pressing this button activates the power to
the unit.
5. To adjust the ember bed lighting, press the
"-" or "+" LAMP buttons. There are four
levels of brightness.
6. The HEATER button activates the heater,
The heater is pre-set to the following
temperatures:
HI will shut off when room reaches approxi-
mately 86° F (30° C). The LED will be red.
MED will shut off when room reaches ap-
proximately 75° F (24° C). The LED will be
orange.
LO will shut off when room reaches ap-
proximately 64° F (18° C). The LED will
be green.
7. To adjust the back flames use the FLAME
button. To increase or decrease flame, press
the "-" or "+" buttons to cycle through the
four flame settings.
ON/OFF
-
+
LAMP
HEATER
FLAME
-
+
Figure 5 - Remote Control For Electric
Fireplace
8
Infrared Ray Exit
Indicator
Light
www.desatech.com
8. To turn off the fireplace, press the ON/OFF
button once. When you restart the fireplace
with the remote control, all of the features
you had set will remain in effect.
NOTICE: This remote control must remain
within 26 ft. (8 m) of the fireplace to be
effective.
CLEANING AND
MAINTENANCE
WARNING: Always disconnect
power and allow the heater to cool
before performing any cleaning,
maintenance or relocation of this
heater. Turn controls to OFF and
remove plug from outlet or turn
off circuit breaker to heater.
Turn off heater and circuit breaker to heater before
performing any cleaning and/or maintenance. Al-
low heater to cool completely.
BACK GLASS
1. The glass is cleaned in the factory during
assembly. During shipment, installation, han-
dling, etc. the glass surface may collect dust
particles. These can be removed by buffing
lightly with a clean dry cloth.
2. To remove fingerprints or other marks, the
glass can be cleaned with a damp cloth using
a good quality household glass cleaner. The
glass should be completely dried with a lint
free cloth or paper towel.
3. In the event of glass breakage, vacuum all re-
maining glass pieces with a shop vac. DO NOT
VACUUM WHILE PIECES ARE HOT. Replace
glass only with replacement part specifically for
this heater. Never substitute material. Only fully
tempered soda lime safety glass may be used on
this heater.
119719-01A
Advertisement
Table of Contents
