NEC EXPRESS5800/140He Service Manual page 116

12. Remove all the initiators in the PCI slots on the electronics bay.
Remove the initiator lock appearing on the rear of the electronics bay. Then pull out the
initiators to remove them.
Insulator (plastic plate)
Insulators locks (indicated by circles)
13. Remove the I/O Board from the electronics bay.
Remove the screws (15) fixing the electronics bay and I/O Board to remove the I/O Board
from the electronics bay.
14. Install the electronics bay in the reverse procedure.
While the electronics bay is inserted into the Server or connected to the Main Board by
using the ejectors, check that no connector pins risk bending and that no cables risk being
caught.
- -
100