Basic Settings; Setting The Language; Setting The Unit Of Measure; Setting The Air Pressure At Sea Level - Sigma Rox 6.0 User Manual

basic settings

setting the language

Set
Reset Mode 2
Set Mode 1
Reset Mode 2
Set Mode 1
Reset Mode 2
Set Mode 1
www.sigmasport.com
4 Basic settings
Press and hold the
Set
display. The preset language then appears.
If you are using the roX 6.0 for the first time and awakening it from deep sleep
mode, it will automatically jump to setting mode without pressing and holding the
button.
Set
Caution
The roX 6.0 can also be set during a ride. not advised and please do so with
caution.
4.1 Setting the language
1 Press the button to switch to the preset language.
Mode 1
2 Press the button. The display flashes.
Set
3 Press or
Mode 2 Reset
4 Press the button to save your setting.
Set
"set oK" appears on the display.

4.2 Setting the unit of measure

1 Press the button to switch to the preset unit.
Mode 1
2 Press the button. The display flashes.
Set
3 Press or
Mode 2 Reset
4 Press the button to save your setting.
Set
"set oK" appears on the display.

4.3 Setting the air pressure at sea level

explanations about this function can be found in section "7 Altitude measurement
(IAc)".
1 Press the button to switch to the preset air pressure.
Mode 1
2 Press the button. The display flashes.
Set
3 Press or
Mode 2 Reset
4 Press the button to save your setting.
Set
"set oK" appears on the display.
roX 6.0
button for three seconds. "setting oPen" flashes on the
to select the desired language.
to switch between km/h and mph.
to increase or decrease the value respectively.
ROX 6.0
Page 16