Opening The Lap View; Calibrating The Start Altitude; Stopwatch; Countdown - Sigma Rox 6.0 User Manual

General roX 6.0 functions

opening the lap view

Lap
Set Mode 1
Reset Mode 2
Set
Reset Mode 2
Set Mode 1
www.sigmasport.com
5.4 Opening the lap view
1 Press and hold the middle button (
flashes on the display.
Press the and
Set Mode 1
time since start, lap distance, distance since start, max. speed, max. heart rate,
calories.
The average heart rate, average cadence, altitude ascent, and lap number are
shown in the top display segment. The average speed for the lap is shown in the
middle display segment.
2 Press the and
Reset
3 Press and hold the
"Lap view cLose" flashes on the display.

5.5 Calibrating the start altitude

simultaneously press and hold the
calibrate the start altitude you have preset. "start altitude" flashes on the display.
If the start altitude has been calibrated, "set oK" appears on the display.
explanations about this function can be found in section "7 Altitude measurement
(IAc)".

5.6 Stopwatch

1 Press the button to move to the stopwatch.
Mode 2
2 Press the button to start and stop the stopwatch.
Set
If the stopwatch is running, the icon
3 resetting the stopwatch:
Press and hold the

5.7 Countdown

1 Press the button to switch to the countdown.
Mode 2
2 Press and hold the
on the display.
3 Press or
Mode 2 Reset
4 Press the button to move to the next digit.
Mode 1
5 Press the button to save your setting.
Set
"set oK" appears on the display.
roX 6.0
) for three seconds. "Lap view oPen"
LAP
button to switch between the following values: lap time,
button to switch between the individual laps.
Mode 2
button for three seconds to exit the lap view.
LAP
and
Mode 1 Mode 2
appears on the display.
button for three seconds.
Reset
button for three seconds. "countdown seT" flashes
Set
to increase or decrease the value respectively.
ROX 6.0
buttons for three seconds to
Page 27