Table of Contents
Advertisement
1 Bay 1 - Maximum Height: 41.3 mm (1.6 in.)
2 Bay 2 - Maximum Height: 41.3 mm (1.6 in.)
3 Bay 3 - Maximum Height: 25.4 mm (1.0 in.)
4 Bay 4 - Maximum Height: 25.4 mm (1.0 in.)
5 Bay 5 - Maximum Height: 25.4 mm (1.0 in.)
6 Bay 6 - Maximum Height: 25.4 mm (1.0 in.)
7 Bay 7 - Maximum Height: 25.4 mm (1.0 in.)
Power and signal cables for internal drives
22
User Guide
The following illustration shows the locations of the drive bays.
The following table describes some of the drives you can install in each bay and
their height requirements.
Notes:
1. Drives that are greater than 41.3 mm (1.6 in.) high cannot be installed.
2. Install removable media (tape or CD) drives in the accessible bays: bay 1 or 2.
Your computer uses cables to connect integrated drive electronics (IDE) drives to
the power supply and to the system board. The following cables are provided:
v Four-wire power cables connect most drives to the power supply. At the end of
these cables are plastic connectors that attach to different drives; these
connectors vary in size. Also, certain power cables attach to the system board.
CD-ROM drive (standard in some models)
5.25-inch hard disk drive
5.25-inch hard disk drive
3.5-inch hard disk drive (requires a mounting
bracket)
CD-ROM drive
DVD-ROM drive
3.5-inch diskette drive (preinstalled)
Hard disk drive
3.5-inch removable drive
Hard disk drive
Hard disk drive
Hard disk drive
Advertisement
Table of Contents
